My gasket..
I used a 1-3/8 punch. Then a leather punch for small holes
The inch and 3/8 is ok for primary. But to big for secondary.
The gap between barrels . doesn't cover all the metal. Should be ok. Hopefully it doesn't blow thru.
Then the small holes in throttle plate need to be cleaned out. 77 drill. Which I broke. Using a pin vise
But they are open..
Picture 3. Don't need that hole.
Picture 4. Packard shows a hole. But nothing there..on bowl.
Attach file:
20210513_202030.jpg (390.50 KB) 20210513_202310.jpg (258.08 KB) 4498_609dfbf7a98c3.jpg (99.07 KB) 20210513_215017_HDR(1).jpg (209.81 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=233491