Re: RIk
Posted by R H On 2021/7/15 18:07:18
Made this plate. Years ago.
Now give it a shot.looks like I will need to cut end of Packard drive .. If not it will sit real high. As is it think there will be an 1/2 inch gap.
The motor does have some torque.
But will see when its hooked up to regulator.
Edit. If I cut the end of the gear drive I'll gain a 1/4inch.
But hate to do it.. Think I'll leave it.
Now have to mill a sq rod and drill a center hole. And then a set screw.
Could not get 12mm sq. Local. So have to use. 1/2 and mill it.
There was a stud in motor drive i cut down....
Edit 7-16.2021
2 different types of armatures.
Are not interchangeable...
The gear is larger than Packard's.
Attach file
:
20210715_155613_HDR.jpg
(233.37 KB)
20210715_155621_HDR.jpg
(229.21 KB)
20210715_155647_HDR.jpg
(188.10 KB)
20210715_161256_HDR.jpg
(195.39 KB)
20210715_161234_HDR.jpg
(205.06 KB)
20210715_161146_HDR.jpg
(241.95 KB)
20210715_161052_HDR.jpg
(169.08 KB)
20210715_161003_HDR.jpg
(249.10 KB)
20210716_210607.jpg
(240.57 KB)
20210716_170654_HDR.jpg
(207.12 KB)
20210716_135107.jpg
(261.78 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=235182