Packard 12 rod beating inserts
Posted by R H On 2021/12/1 15:41:27
Drilling holes for new bearings
Bottom picture is new rod and insert I drilled. New rods holes are in center of rod.
The small hole is 60 degrees off center.
The jig. I think my dad made for getting Babbitt off of copper.
Still need to put a fillet on the little hole
Attach file
:
20211128_193830_HDR.jpg
(240.85 KB)
20211128_193919_HDR.jpg
(184.18 KB)
20211128_193928_HDR.jpg
(176.17 KB)
20211130_115356_HDR.jpg
(204.08 KB)
20211130_115409_HDR.jpg
(234.10 KB)
20211130_192930_HDR.jpg
(176.78 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=239173