Re: Wes's Maroon 1947 Custom Super Clipper
Posted by Wesley Boyer On 2020/6/22 0:58:55
Thanks PackardDon!
Well moving on, working on getting the Drivers side Light Bucket painted and rewired. Got my wires from Rhode Island Wiring, also picked up 7/16 by 1/16 Neoprene Tubing for the five wires going into the bucket from the junction block. I also added a short piece of heat shrink tubing where it goes into the bucket to help slide the tubing though the grommet. So far it doesn't look to bad. I've been trying to reuse as much hardware as possible.
Next installing the inner ring and the springs, hopefully it won't be too difficult, famous last words!
Wes
Attach file:
(162.76 KB)
(226.47 KB)
Well moving on, working on getting the Drivers side Light Bucket painted and rewired. Got my wires from Rhode Island Wiring, also picked up 7/16 by 1/16 Neoprene Tubing for the five wires going into the bucket from the junction block. I also added a short piece of heat shrink tubing where it goes into the bucket to help slide the tubing though the grommet. So far it doesn't look to bad. I've been trying to reuse as much hardware as possible.
Next installing the inner ring and the springs, hopefully it won't be too difficult, famous last words!
Wes
Attach file:
(162.76 KB)
(226.47 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=223703