Re: Wes's Maroon 1947 Custom Super Clipper

Posted by HH56 On 2020/7/29 8:52:54

A shaft for the lever comes out a hole on the bottom and lever bolts on to the switch shaft. Wires go thru another hole and down the shroud to end a few inches past the edge of dash. Also take a good close look at the speedo face to see if there are small arrow cutouts between 3 < 4 and 7 > 8. The steering wheel hub should be drilled for the cancel pins and those can be done with roll pins.

You could actually do without the arrows and mount the indicator lights somewhere else If you have the holes in the column for the switch. It would then just be a matter of making a loom and buying the switch and flasher. Parking lights should already be wired but new tail light housings for the second bulb and getting the wires to the trunk might need to get creative if the headliner is still in place.