Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2014/10/12 17:50:21
You guys were dead on.
I removed the two bolts this morning to remove the lower A arm and the T/L load arm pivot bracket raised up about 1/4 inch. After the A arm fell to the shop floor I immediately put the two bolts back in place. Will leave them there until I resemble. Thanks again.
Attach file:
(110.72 KB)
I removed the two bolts this morning to remove the lower A arm and the T/L load arm pivot bracket raised up about 1/4 inch. After the A arm fell to the shop floor I immediately put the two bolts back in place. Will leave them there until I resemble. Thanks again.
Attach file:
(110.72 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=151193