Re: Stewart's 1955 Packard 400

Posted by Troy Taylor On 2014/10/26 20:07:07

Stewart,

Looking good. I may have to speed up, you are catching up to me.

On the rubber grommets, I used heat and the rubber and inner sleeve will drop out. the Outer steel sleeve is a bear. I used a cut off wheel and made several cuts down to the arm, Heat again and then alot of air hammer and chisel. Once it breaks free it will go but it is very slow. Took me about 15 min per bushing. On the lower arm, heat and air hammer, then burn out the rear rubber so the new bushing will go in.