Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2014/12/28 12:41:15
Working on the engine a little today. If I can get the oil pump and pan done I can roll it over and start working on the rest.
I got a question.
I have the Oldsmobile oil pump that I got from Jack Vines. The directions he provided says that I would have to grind off a corner of the pump so that the oil pan will fit. I have been grinding in the circled area below and the oil pan is not getting much closer. Before I go any further I wanted to make sure I was grinding in the right location.
Attach file:
(36.93 KB)
I got a question.
I have the Oldsmobile oil pump that I got from Jack Vines. The directions he provided says that I would have to grind off a corner of the pump so that the oil pan will fit. I have been grinding in the circled area below and the oil pan is not getting much closer. Before I go any further I wanted to make sure I was grinding in the right location.
Attach file:
(36.93 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=155284