Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2015/2/14 11:59:19
Thanks for the info.
I pulled the rear end back apart this morning. I have not yet put the shafts back in nor have I torqued it down so it was an easy job.
Those washers on the studs are definitely plastic. I just did not inspect them closely and assumed it was just a lip on the studs.
Used my pocket knife to work each one up and off the studs. One was broken and several others have bites out of them.
I may use the Ultra Grey RT as suggested but would like to replace these as well. Are O Rings a poor substitute? I'm not seeing replacements on Max's web site but I need to call them this week anyway so I will ask.
Attach file:
(75.38 KB)
(54.84 KB)
(48.12 KB)
I pulled the rear end back apart this morning. I have not yet put the shafts back in nor have I torqued it down so it was an easy job.
Those washers on the studs are definitely plastic. I just did not inspect them closely and assumed it was just a lip on the studs.
Used my pocket knife to work each one up and off the studs. One was broken and several others have bites out of them.
I may use the Ultra Grey RT as suggested but would like to replace these as well. Are O Rings a poor substitute? I'm not seeing replacements on Max's web site but I need to call them this week anyway so I will ask.
Attach file:
(75.38 KB)
(54.84 KB)
(48.12 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=157475