Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2015/4/7 18:51:44
I am going to have to ask this question again. TroyT provided an answer before but I am just trying to make sure as I am still not clear how this goes back together.
I am thinking that I misunderstood the earlier instructions.
Are either of the images below close to being correct or does this strange shaped piece of rubber with the rectangular hole really go down over the larger round rubber piece (the one that holds in the grease for the torsion bar).
Attach file:
(103.91 KB)
(83.64 KB)
I am thinking that I misunderstood the earlier instructions.
Are either of the images below close to being correct or does this strange shaped piece of rubber with the rectangular hole really go down over the larger round rubber piece (the one that holds in the grease for the torsion bar).
Attach file:
(103.91 KB)
(83.64 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=160134