Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2016/12/30 22:23:18
I believe this is the 2 bolt riser on Summit below.
Looking at it I think that the orientation of the spring & weight is different then the original riser. The whole assembly, when bolted in, is really close to the frame on that side so it may not bolt in. I think the spring needs to be closer toward the front of the engine not the rear as this one is. I will take a closer look at it tomorrow morning.
Attach file:
(8.21 KB)
Looking at it I think that the orientation of the spring & weight is different then the original riser. The whole assembly, when bolted in, is really close to the frame on that side so it may not bolt in. I think the spring needs to be closer toward the front of the engine not the rear as this one is. I will take a closer look at it tomorrow morning.
Attach file:
(8.21 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=186294