Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2017/7/17 21:12:29
Our harvest is finally complete and I get a few hours on my more important project each week.
I am finally getting the undercoating applied to the underside of the body. I am using the Rust-o-leum truck bed liner. Using a roller to apply most of it but also using cheap foam brushes to apply in tight spots. Giving two coats to everything.
I am about 3/4 done. Am skipping the area where the fuel tanks goes for now. I'll get that after I get the spare tire well back in place and I can do that after I get the body back onto the frame in a month or two. As you can see, in that area, I am only applying the undercoat where the frame well set and I won't be able to get to it later.
I still have to do the very front of it under the front floor pan but will have that done in the next week two.
I ordered all the rubber body mounts last week. Got some sticker shock from that.
Attach file:
(131.00 KB)
(77.58 KB)
(96.64 KB)
(130.66 KB)
I am finally getting the undercoating applied to the underside of the body. I am using the Rust-o-leum truck bed liner. Using a roller to apply most of it but also using cheap foam brushes to apply in tight spots. Giving two coats to everything.
I am about 3/4 done. Am skipping the area where the fuel tanks goes for now. I'll get that after I get the spare tire well back in place and I can do that after I get the body back onto the frame in a month or two. As you can see, in that area, I am only applying the undercoat where the frame well set and I won't be able to get to it later.
I still have to do the very front of it under the front floor pan but will have that done in the next week two.
I ordered all the rubber body mounts last week. Got some sticker shock from that.
Attach file:
(131.00 KB)
(77.58 KB)
(96.64 KB)
(130.66 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=194067