Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2020/6/26 19:06:08
Thank you everyone and a special thank you to Ross. Should have thought of that myself.
I pulled the rocker and ran the pump. I wa snto prepared for the amount of oil that flowed out. I set the rockers back in place without the bolts and ran the pump again. That little glob in the image below shot out of the far right bolt hole.
Put the bolts in place with just a couple turns and everything is still good but when I tighten the bolts down (not torqued) the flow cuts of again.
I guess I need to dissemble that rocker and clean it out again this weekend.
Stewart
Attach file:
(153.32 KB)
I pulled the rocker and ran the pump. I wa snto prepared for the amount of oil that flowed out. I set the rockers back in place without the bolts and ran the pump again. That little glob in the image below shot out of the far right bolt hole.
Put the bolts in place with just a couple turns and everything is still good but when I tighten the bolts down (not torqued) the flow cuts of again.
I guess I need to dissemble that rocker and clean it out again this weekend.
Stewart
Attach file:
(153.32 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=223937