Re: Stewart's 1955 Packard 400

Posted by HH56 On 2020/10/29 21:15:56

There was a photo posted of the fenders in the paint shop. It looked like they were on some sort of support that held them at an angle. What about some 2x4s to make a sawhorse or A frame cut at a length the fender top is at a convenient height with enough width it lays the fender at an angle where you can get to everything at the bottom without too much bending or kneeling. You could work from both sides and also sit on a low stool if there was body work to be done.