Re: Stewart

Posted by d c on 2021/8/2 11:21:43
Looking good. On the cluster-have you had one of the speedo rebuilt or tested? Have you plans to replace the gauge voltage regulator with a new original style or a solid state? These are very hard to access after all is installed and the car is back on the road. If your orig speedo ad the needle broken it may have had the dreaded needle bounce these are prone to. Test your replacement with a cordless drill and a full length speedo cable to check for bounce. Pay careful attention to dust,rust, dried lube on the odometer gears. Clean all with wd40 and tooth brush carefully without staining odometer barrels.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=235653