Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard on 2021/9/12 20:24:01
The D shaft on the original motor is .312 (5/16). The measurements of the 2 motors are very similar. The only unknown is the distance between those two mounting bolts on the new motor. I think the flange will allow me to re-drill the holes if the new motor is smaller. I don't think there is enough room if its larger but again if I purchase from Amazon I can easily return it if its wrong.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=236823