Re: Stewart's 1955 Packard 400

Posted by kevinpackard On 2021/9/21 17:54:47
It seems like it would be a lot of work to pull the body off and gain access to that area.

Cutting and welding in a new patch can certainly be done. Three concerns about that would be: 1.) how would it look under the carpet afterwards, 2.) welding sheet metal is no fun, and 3.) would you want to do any sort of protection on the underside of that patch will be hard to access.

Either way it's going to be some work. But it sounds like you may have found the problem, and that's good.


This Post was from: