Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2021/9/22 19:24:46
I found the updated instructions on there site and it does say "There should not be any cutting or welding required, but some areas may need slightly enlarged with a rubber mallet, or equivalent."
Unfortunately I installed it all differently. The engine and trans were already on the frame when I dropped the body in place.
When all the body mount holes aligned I assumed all was good to go...until this week when I tried to mount the fender.
The trans is not sticking up thru the hole right now. If I get the body to move forward it may stick out then.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=237126