My 400 must have been pre-wired for an under-seat heater. One wire went to the heater fuse and the other just ended at an unused connector. I'll just clean it up and install it for looks only.
I got the heater valve back together. I used a shop press with just enough pressure to push it together. I don't have all the external parts back in place yet but the hard part is done. I don't know if its a good test of not but I filled both tubes with water and it held water (with no pressure). I hope its OK.
Attach file:
ValveJig.jpg (192.56 KB)
ValveJig2.jpg (173.77 KB)
Pressed.jpg (181.03 KB)
Assembled.jpg (251.16 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=239209