Re: Stewart
Posted by Stewart Ballard On 2021/12/22 17:47:58
I tabled a door today. First time I have done anything with them in a few years.
There are rust holes in the corner but surrounding area seems solid.
There is heaving pitting under the Reynolds wrap.
There was a collision at some point in its history as I removed some bondo from the center of the door.
The forward edge is bent inwards as if someone had forced the door open to far.
There are three 1/2" holes punched into the very bottom of the door. I am guessing someone though it needed more drainage.
It sounds like a lot but it isn't any worse then the rest of the car was. Looks like fun.
Attach file:
rust1.jpg (232.12 KB)
rust2.jpg (289.59 KB)
pitting.jpg (227.54 KB)
ImpactAndBondo.jpg (211.97 KB)
Bent.jpg (207.91 KB)
DrainHoles.jpg (128.68 KB)
Door1.jpg (192.18 KB)
There are rust holes in the corner but surrounding area seems solid.
There is heaving pitting under the Reynolds wrap.
There was a collision at some point in its history as I removed some bondo from the center of the door.
The forward edge is bent inwards as if someone had forced the door open to far.
There are three 1/2" holes punched into the very bottom of the door. I am guessing someone though it needed more drainage.
It sounds like a lot but it isn't any worse then the rest of the car was. Looks like fun.
Attach file:
rust1.jpg (232.12 KB)
rust2.jpg (289.59 KB)
pitting.jpg (227.54 KB)
ImpactAndBondo.jpg (211.97 KB)
Bent.jpg (207.91 KB)
DrainHoles.jpg (128.68 KB)
Door1.jpg (192.18 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=239773