Re: Stewart
Posted by Stewart Ballard On 2022/3/16 18:31:26
The steering column has been repainted and re-assembled. I do still need to clean up the reverse switch and install the new plug on the wire harness. I have to be real careful with that as the two harnesses are no longer color-matched but, I have that under control.
Also started taking all the bits and pieces off that left side door. Now I remember why I did not disassemble it at the same time I did the right side door a few years ago. That clip that holds the door handle in place is a PITA with surface rust. It is going to take a drimmel to get it apart.
Attach file:
Reassembled1.jpg (79.55 KB)
Reassembled2.jpg (81.16 KB)
I-HateThisPiece.jpg (82.38 KB)
Also started taking all the bits and pieces off that left side door. Now I remember why I did not disassemble it at the same time I did the right side door a few years ago. That clip that holds the door handle in place is a PITA with surface rust. It is going to take a drimmel to get it apart.
Attach file:
Reassembled1.jpg (79.55 KB) Reassembled2.jpg (81.16 KB) I-HateThisPiece.jpg (82.38 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=241936