Went out to the shop tonight to take some measurements of the exhaust ports on the plenum and defrosters under the dash.
There are two different sizes. One size for both the left ports and one size for the right side ports.
For the right side, I can use a 2x4 scrap as a mold and do noo even have to cut if down. The left side is about a 1/2 longer so I can rip a scrap 2x6 for that mold. I have already ordered some sheets of ABS plastic. I am looking forward to attacking this.
Also, I have some door glass and vent windows on the way from Southwest Packard to replace some broken glass that I have.
Attach file:
LeftSide.jpg (144.74 KB) RightSide.jpg (174.77 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=253610