Re: Stewart
Posted by Stewart Ballard On 2023/3/25 17:58:30
I was thinking the same thing last night.
I have been looking for a channel to place inside the division bar that is circled below. Now I think the division bar WAS the original channel. All the soft fuzzy stuff dried up and fell out. So, the correct answer is the replace that whole bar with a new rigid channel.
That is going to be a PITA because I already have the vent window seals riveted in place. I think I will call Rubber the Right Way Monday and see if something like the seal in the 2nd image can be used inside the original channel. The metal frame (that slides in that channel) that is on the door glass is only 1/8 thick. It will not have the stainless bead but at this point, I am tired if thinking about it.
Attach file:
vents.jpg (127.62 KB)
seal.png (194.56 KB)
I have been looking for a channel to place inside the division bar that is circled below. Now I think the division bar WAS the original channel. All the soft fuzzy stuff dried up and fell out. So, the correct answer is the replace that whole bar with a new rigid channel.
That is going to be a PITA because I already have the vent window seals riveted in place. I think I will call Rubber the Right Way Monday and see if something like the seal in the 2nd image can be used inside the original channel. The metal frame (that slides in that channel) that is on the door glass is only 1/8 thick. It will not have the stainless bead but at this point, I am tired if thinking about it.
Attach file:
vents.jpg (127.62 KB)
seal.png (194.56 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=255181