Re: Stewart
Posted by Stewart Ballard On 2023/6/25 17:32:39
I figured out the gear shifht linkage. found one on eBay and should have it this week.
The brake lines are nearly filled. Should have that done this week as well.
Also got that return spring installed for the throttle while I was underneath working the rear brakes.
A new fuel tank has been ordered this past week and I have measured for a new drive shaft. I may order that in the next couple of weeks.
Finally got the replacement door hinge painted and installed but it did not help the sagging problem. It is still an inch too low at the outside end of the door. The second photo shows where it's hitting inside. I am afraid that I am going to have to drill the holes on the hinges larger to allow a little more movement. They are drilled for 3/8 bolts now. May have to go to a 7/16 hole.
Attach file:
20230625_141710_resized.jpg (36.32 KB)
20230625_155147_resized.jpg (41.75 KB)
20230623_114556_resized.jpg (74.26 KB)
The brake lines are nearly filled. Should have that done this week as well.
Also got that return spring installed for the throttle while I was underneath working the rear brakes.
A new fuel tank has been ordered this past week and I have measured for a new drive shaft. I may order that in the next couple of weeks.
Finally got the replacement door hinge painted and installed but it did not help the sagging problem. It is still an inch too low at the outside end of the door. The second photo shows where it's hitting inside. I am afraid that I am going to have to drill the holes on the hinges larger to allow a little more movement. They are drilled for 3/8 bolts now. May have to go to a 7/16 hole.
Attach file:
20230625_141710_resized.jpg (36.32 KB) 20230625_155147_resized.jpg (41.75 KB) 20230623_114556_resized.jpg (74.26 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=258534