Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2023/11/22 14:03:43
I identified the mount holes for a couple of the rear regulator brackets.
The straight, lower bar in the first image was easy.
The second image shows the bar that pivots the window up and down. I think I have located the holes to mount it. I know how this arm connects to the regulator itself.
The third image is the regulator bracket. If the top left bracket hole uses the hole just below where the glass pivots then the other two holes do not reach anything.
I have it oriented as the drawing shows it. It would not surprise me if I am holding the whole thing upside down.
Attach file:
20231122_132022_resized.jpg (213.51 KB)
20231122_132935_resized.jpg (175.65 KB)
20231122_133227_resized.jpg (158.67 KB)
The straight, lower bar in the first image was easy.
The second image shows the bar that pivots the window up and down. I think I have located the holes to mount it. I know how this arm connects to the regulator itself.
The third image is the regulator bracket. If the top left bracket hole uses the hole just below where the glass pivots then the other two holes do not reach anything.
I have it oriented as the drawing shows it. It would not surprise me if I am holding the whole thing upside down.
Attach file:
20231122_132022_resized.jpg (213.51 KB)
20231122_132935_resized.jpg (175.65 KB)
20231122_133227_resized.jpg (158.67 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=264846