Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2024/4/3 18:29:23
Worked on the power seat some today.
My Painless wire harness has a few spare circuits and one of them is 30 amp for an A/C.
I pulled the motors off and tested them using that circuit and they worked fine.
I tried turning the seat movements manually with the motors off and the backward movement was pretty tight.
It may be binding where it is circled in the first image. Not sure how to fix that. I am hoping the seat frame is just a little too far forward or backward on one side.
The second image shows the shaft and how far I still have to go to move the seat backwards.
Attach file:
20240403_160047_resized.jpg (1,626.98 KB)
20240403_163457_resized.jpg (539.27 KB)
My Painless wire harness has a few spare circuits and one of them is 30 amp for an A/C.
I pulled the motors off and tested them using that circuit and they worked fine.
I tried turning the seat movements manually with the motors off and the backward movement was pretty tight.
It may be binding where it is circled in the first image. Not sure how to fix that. I am hoping the seat frame is just a little too far forward or backward on one side.
The second image shows the shaft and how far I still have to go to move the seat backwards.
Attach file:
20240403_160047_resized.jpg (1,626.98 KB)
20240403_163457_resized.jpg (539.27 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=269697