Re: HA's 52 200 Grey Ghost

Posted by HH56 On 2014/3/12 20:41:29

How does the sealer application handle the pickup tube inside the tank?

Usually not a problem with sealer getting inside the tube although it might be a good idea to give it a blast of air when you finish sloshing just to be sure.

The one thing you absolutely do not want to do after draining the excess out is leave the tank laying flat with the bottom down to cure. The remaining sealant will eventually puddle in the triangular depression where the pickup tube open end sits and block it tighter than you can imagine. If that happens, it is a bitch if not sometimes impossible to open the tube. Let the tank dry at an angle so the excess will flow to one of the sides.