Re: 51Packards....52 Packard 200 Deluxe!
Posted by Charles On 2014/6/26 20:44:02
6-26-14
Finally finished rebuilding the carb. Had some issues getting the metering rods to seat. Had to take one off the lifter mechanism, screw the two halves of the carb together again, then reattach the metering rod with the tips of two screwdrivers.
Also lost the rod that opens the throttle valves. Not sure where it went. I took the one off the '51 carb for now until it shows up (hopefully).
Some of the adjustments in the instructions were a little confusing to me so I hope it works!
I'll put it on the car this weekend and see if there is an improvement.
Attach file:
(98.87 KB)
Finally finished rebuilding the carb. Had some issues getting the metering rods to seat. Had to take one off the lifter mechanism, screw the two halves of the carb together again, then reattach the metering rod with the tips of two screwdrivers.
Also lost the rod that opens the throttle valves. Not sure where it went. I took the one off the '51 carb for now until it shows up (hopefully).
Some of the adjustments in the instructions were a little confusing to me so I hope it works!
I'll put it on the car this weekend and see if there is an improvement.
Attach file:
(98.87 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=145981