Re: Wayne's 56 400
Posted by WW400 On 2014/8/1 6:56:28
31/7/2014
Fitted a Packard wheel to replace a bodged up one which had the wrong stud patern. Car rolls better now.
Tried to fit the rear 55 bumper I have but the 56 brackets have a larger off centre cam like bolt so I need to find a drill press.
1/8/2014
Fitted the glovebox door but found one hinge fouled on the starter switch. What did I do wrong?
Noticed some holes for a small plaque on the drivers side front fender, where they put the Esquire badge. Who would put such a small plaque on their car?
Next task is to get the trunk lid to close. But need a new hinge. Would 51-54 Clipper hinges fit?
Attach file:
(12.01 KB)
(34.21 KB)
(29.67 KB)
(43.34 KB)
Fitted a Packard wheel to replace a bodged up one which had the wrong stud patern. Car rolls better now.
Tried to fit the rear 55 bumper I have but the 56 brackets have a larger off centre cam like bolt so I need to find a drill press.
1/8/2014
Fitted the glovebox door but found one hinge fouled on the starter switch. What did I do wrong?
Noticed some holes for a small plaque on the drivers side front fender, where they put the Esquire badge. Who would put such a small plaque on their car?
Next task is to get the trunk lid to close. But need a new hinge. Would 51-54 Clipper hinges fit?
Attach file:
(12.01 KB)
(34.21 KB)
(29.67 KB)
(43.34 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=147856