I started cutting out the bad metal in the back seat area against the inner fender wells. This section isn't all that bad overall, just a few pinholes here and there. I also cut out the bottom of the dividing panel between the cab area and the trunk so I could get in there to blast better. There was rust between the layers that had to be cut out anyway.
Attach file:
(69.43 KB)
(64.59 KB)
(96.93 KB)
(45.00 KB)
(65.63 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=160121