Got most of the lead work done, ran out of lead sticks before I was able to finish the last rear quarter/trunk panel seam. I melted out the last two spots I had left on for reference and blasted the areas to clean out the rust that was underneath. The top pic shows just how far the edge was pounded in from the factory. Also filled the driver side upper quarter panel seam, and the door jamb seams.
Attach file:
(38.27 KB)
(31.82 KB)
(42.86 KB)
(33.99 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=161800