Re: Ken's 1937 120 Touring Sedan
Posted by Ken_P On 2020/11/22 19:51:53
Any thoughts on the vibration damper? Hope I'm ok, since the front clip is back on.
Put the splash guards back on. Did quite a bit of tin knocking on the drivers side; didn't on the passenger side because it had some rust and I'll replace it eventually.
Set the valves with the engine warm and idling. They were all loose. So much quieter. Lots of burns on the knuckles though! I also put plugs in the vacuum side of the fuel pump, so it would stop making noise. I don't have the wipers hooked up right now.
I also have didn't hook up the heater for now, and I installed a gano filter. I flushed the block, but if I see too much rust in the filter, I'll run evaporust for a few months. I had the radiator gone through, and I don't want to clog it!
Got the front clip in place. Need to put a few more bolts in, then get everything adjusted. Then DRIVE!!!!
Attach file:
(328.28 KB)
(269.18 KB)
Put the splash guards back on. Did quite a bit of tin knocking on the drivers side; didn't on the passenger side because it had some rust and I'll replace it eventually.
Set the valves with the engine warm and idling. They were all loose. So much quieter. Lots of burns on the knuckles though! I also put plugs in the vacuum side of the fuel pump, so it would stop making noise. I don't have the wipers hooked up right now.
I also have didn't hook up the heater for now, and I installed a gano filter. I flushed the block, but if I see too much rust in the filter, I'll run evaporust for a few months. I had the radiator gone through, and I don't want to clog it!
Got the front clip in place. Need to put a few more bolts in, then get everything adjusted. Then DRIVE!!!!
Attach file:
(328.28 KB)
(269.18 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=228217