Re: Mike's 53 Clipper
Posted by Tobs On 2015/2/14 15:43:20
The product on the website that I posted the link to melts at a higher temp than the muggy weld, I may order one of the muggy weld DIY kits....
I was in the garage today and did some easy jobs. Cut a board to go between the back seat and trunk, and new panels to go in the holes in the doors and back seat. A few pics some better than other of todays progress.
I am not sure which way the tube between the exhaust manifold and the choke should go. Over or under the ruber hose that goes to the heater core?
I mocked it up with welding rod in two pictures. Anybody know which way is correct for a 53 clipper?
Happy Valentines day!
edit....looking at some old pictures of my engine, the choke stove tube ran above the heater hose....
Attach file:
(77.56 KB)
(50.89 KB)
(108.67 KB)
(95.87 KB)
I was in the garage today and did some easy jobs. Cut a board to go between the back seat and trunk, and new panels to go in the holes in the doors and back seat. A few pics some better than other of todays progress.
I am not sure which way the tube between the exhaust manifold and the choke should go. Over or under the ruber hose that goes to the heater core?
I mocked it up with welding rod in two pictures. Anybody know which way is correct for a 53 clipper?
Happy Valentines day!
edit....looking at some old pictures of my engine, the choke stove tube ran above the heater hose....
Attach file:
(77.56 KB)
(50.89 KB)
(108.67 KB)
(95.87 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=157487