Re: Mike's 53 Clipper

Posted by Tobs On 2017/5/3 1:51:33

I tried an extra ground this morning, and it did not help. The gauge worked for a while (with the livable problem of reading 1/4 when empty) and then a few days after I filled the tank up all the way for the first time, it started reading empty, so I'm guessing either the float sunk or the sensor went bad....I remember there was a post of the measurements on where to cut the trunk to get at the sensor, I will consider cutting a hole to make this job easier....

Regarding the metal tire valve stems, anybody know the diameter of the hole in the rim for the stem?