Re: Mike's 53 Clipper

Posted by Tobs On 2017/9/15 14:17:33

I installed the Drok voltage reducer today. I mounted it to the bottom of the dash near where the handbrake is, so it can vent any heat it might generate. I only tested the fuel and temp gauge in the garage. (key on and engine not running) So far, it works. The gas gauge might be lower than before, but I have to evaluate it after a drive. (It seemed to read high before, so this might be better)
It has been rainy here the last few days. I hope it dries up, and I can see if the gauges are accurate and steady with this power supply.