Re: Mike's 53 Clipper

Posted by Tobs On 2017/9/18 8:40:16

I went for a drive over the weekend and got up to normal operating temp. As you can see, the temp needle points at the right edge of the T in TEMP. I think this is a little lower than previously, but only a little difference. IIRC, the needle used to point between the T and the E. So far it seems to work ok, and I hope I can forget about this and work on other things. At least for now, the DROK seems like a viable replacement for the original chopper voltage reducers.

Attach file:

---

  (182.41 KB)