Re: Mike's 53 Clipper

Posted by JWL On 2019/7/24 11:50:15

Here's an idea. Rig a length of 1/8" rubber tubing to fasten to a small nipple on the top of the cap and then directed down. This will allow for spillage to escape without hurting paint and keep the tank ventilated. I haven't done this but it may be an answer. JWL

Mod I: Route the rubber tubing so it is looped above the gas filler level. This "trap" may keep any gas from spilling. The bottom part of the tubing can be secured to the filler pipe with zip ties.