Re: PTV's 1951 Packard 200

Posted by Hans Ahlness On 2016/2/24 14:36:16
not hard to replace the horn wire, but you do have to disassemble the horn button etc from the steering wheel. tape or solder a new length of wire to the bottom end and use the original wire to pull it through, then reinstall the horn button end of the wire (electrical connection for grounding the horn relay) to your new wire. I actually used the old horn button end and attach it to the new wire with connectors so I could remove it to remove the steering wheel, as I was on and off a couple times later. just insulate the connection so it doesn't ground and sound the horn when you don't intend that to happen. leave some extra at the bottom end so you can pull the whole shebang out a bit to disconnect your wire if/when you need to remove the steering wheel sometime.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=172799