Riki-Ultra
Posted by Troy Taylor On 2016/2/15 18:16:04
Riki- Hope you don't mind, I cant send pics via the IM.
The entire converter pump housing should fit inside the bell housing.
With the Purple converter in the pic, this converter is not yet fully seated, their should be no gap between the pump and converter housings. You should not be able to see the silver lip of the pump cover.
The Green pump is fully seated and the converter clutch housing is basically flush with the bell housing.
If you have some burs on the pump, they can sometimes be a bit difficult, but you just need to rotate, wiggle and push, they will slip on. the fact that you had to rubber mallet yours on is a bit concerning.
Make sure you do not have any binding and your sprag is still working properly.
Attach file:
(19.44 KB)
(16.35 KB)
The entire converter pump housing should fit inside the bell housing.
With the Purple converter in the pic, this converter is not yet fully seated, their should be no gap between the pump and converter housings. You should not be able to see the silver lip of the pump cover.
The Green pump is fully seated and the converter clutch housing is basically flush with the bell housing.
If you have some burs on the pump, they can sometimes be a bit difficult, but you just need to rotate, wiggle and push, they will slip on. the fact that you had to rubber mallet yours on is a bit concerning.
Make sure you do not have any binding and your sprag is still working properly.
Attach file:
(19.44 KB) (16.35 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=172325