Re: Henry's 37 Limousine

Posted by Cli55er On 2016/8/31 11:58:37

well here is what I did last night but had to take apart because the fuel pump wire ran to the back of the car on the wrong side and there was no switch wire for it. so I had to cut the fuel pump power wire so I could wire one side to the switch and then use the rest that pulled out to go to the pump down the other side of the car.

I had it all decent looking too. damnit!

I'm not sure why the people that wired this before used such huge wires to run the fans, maybe because its dual fans on a single wire. I do know that the harness did supply a acc battery wire for the fans and a switch wire that goes to the fans, unlike the fuel pump as described above.

the wires are probably like 16 gauge. not sure if it will run the fans. the wires the other person ran are like 8 gauge...you can see them in the pics...the two red ones going down the kick panel with the harness.

Attach file:

---

  (41.85 KB)


  (30.37 KB)