Re: Henry's 37 Limousine

Posted by Cli55er On 2016/12/8 12:33:23

Turned off from posting here. still not really into it much, but i'm forcing myself because I'm trying to not let one person ruin my fun. thats all i have to say about that.

motor has been back for some time. i tried to get as much done as i could before my ablation. the ablation turned out okay, the aftermath has been a journey in recovery to say the least.

here are some pictures of what i have been up to. machine shop didn't have a way to keep the intake and exhaust manifold together to deck them. so becuase there were several large pits in the surface of the matting surface in the exhaust manifold. i heated it.....welded it....and ground it by hand and eyed it. if it was sealing before this it should be good enough to seal now expecially since it is much flatter then before. red arrows in pictures show my welding. 90 amp wire flux welder, very clean sand blasted manifold and good heat before welding.

don't really have much more to talk about. meh...

Attach file:

---

  (35.79 KB)


  (33.25 KB)


  (44.67 KB)


  (43.10 KB)


  (47.35 KB)


  (22.94 KB)


  (28.19 KB)


  (30.88 KB)


  (25.96 KB)


  (32.91 KB)


  (30.62 KB)


  (34.05 KB)


  (47.31 KB)


  (41.74 KB)


  (33.84 KB)


  (42.83 KB)


  (35.15 KB)


  (31.94 KB)


  (37.72 KB)


  (34.37 KB)


  (48.69 KB)


  (42.85 KB)


  (39.62 KB)


  (33.27 KB)


  (31.51 KB)


  (47.13 KB)


  (35.08 KB)


  (22.23 KB)


  (37.81 KB)


  (31.73 KB)