Re: Henry's 37 Limousine

Posted by Cli55er On 2017/8/8 10:21:32

Thanks Kev. I got the glass out last night and I can tell you someone did a poor job of cutting it, but it does fit.

sanders says the glass should be 16x22, but the one I took out was 14x21. and I barely had just enough wiggle room to pull it out from the top without removing the wing window. I just had to remove the window channeling from the door handle side of the door. it was just held in by press fit and one screw. the joys of aftermarket replacement type stuff.

since the glass I took out worked fine before, i'm going to have them just cut the new one the same, this way I can get it back in the same way I took it out. with the new channeling they installed before me, it will be impossible to get a 22" wide window in there I can tell you that.

it had been in there for years as it was not the easiest to get out of the support bar that ran along the bottom. the rubber cushion that ran in the bar was pretty petrified and stuck.

one thing I found funny....the window had etched in the corner.....SHAT-R-PROOF. HAHAH they said shat! lmao. it was the only window that had any etching on it still, the rest were blank.

Attach file:

---

  (27.51 KB)


  (17.54 KB)