Re: 1930 boat tail speedster from a rough starting point
Posted by Mike Bartrom On 2016/11/24 23:59:00
I know that it is Thanksgiving (happy Thanksgiving!!!) But I did get to work a few hours this morning while everyone was sleeping.
I built the inner doors. The picture shows both inner door sheets of 14 awg welded together at the corners. I cut the access holes out with a 2" hole saw and a cutoff wheel.
Next I'll make the frames, then put on the skins. After all of that I'll be able to finish the cowl edge so it flows into the tops of the doors.
Attach file:
(113.05 KB)
I built the inner doors. The picture shows both inner door sheets of 14 awg welded together at the corners. I cut the access holes out with a 2" hole saw and a cutoff wheel.
Next I'll make the frames, then put on the skins. After all of that I'll be able to finish the cowl edge so it flows into the tops of the doors.
Attach file:
(113.05 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=184939