Re: 1940 Packard 110 project car

Posted by Corey On 2016/11/28 22:07:02

I'm gonna do lot's of metalwork on my car my grandpa said he can get me flat sheet metal for the floors and trunk he think's I'm gonna rat-rod it but I'm not I plan on keeping it all Packard until it comes to metal I'm gonna make my own inner fender wells the front fenders can be fixed but I might buy an extra set when I get the cash the rear fender's aren't bad surface rust but the bottom of the fender's are rotted out I can cut that off and make new bottoms the floorboards need to be sanded other than that they're in good condition the roof has surface rust I'm gonna need a new Trunk lid and hinges though but so far what I really need I'll list out
1-1940 straight 6cyl
2- 1940 3-speed manual tranny
3- 1940 rear-end
4- 1940 front door hinges
5- 1940 rear-doors
6- 1940 Radiator
7- I'm gonna need a better dash for my car eventually
For the Interior I'm gonna need front and back seats I can make my own carpeting for the car and make my own headliner If that's aloud