Re: Joe's '49 Club Sedan

Posted by Joe Wareham On 2018/12/19 15:26:48

After the carpet was installed, The kick panels, brake and clutch pads and gas pedal were added.

The rear panels and arm rests were the next to be installed then the back of the rear seat. The rear window moldings and window cranks were added.

A pair of rear seat belts were attached to the body with Grade 8 bolts then the bottom of the back seat was snapped in.

The front seat was cleaned is ready to install as soon as I can enlist some help to lift it in.

In the meantime, I'm gathering everything else that will go in after the front seat. That includes the front door panels and window moldings, the steering wheel assembly and shifter and the interior and exterior division bars for the windshield.

Hope to have the engine started before Christmas and driving before the end of the year. This will finally answer the question about whether my improvised gas gauge sender and gauge will actually work!

Attach file:

---

  (152.69 KB)


  (91.38 KB)


  (83.62 KB)


  (74.18 KB)


  (74.95 KB)


  (58.96 KB)


  (86.22 KB)