Re: Joe's '49 Club Sedan

Posted by Joe Wareham On 2020/2/28 10:16:24
Before the dash could be re-installed, holes had to be cut for the AC vents. A 2 1/2" Blair "Holcutter" was used to cut holes in each side of the dash. A center vent will be added in the area of the heater/defrost knobs in the lower center of the dash.

Attach file:


jpg  (109.98 KB)
8531_5e592eaf8d948.jpg 1024X768 px

jpg  (91.88 KB)
8531_5e592ebd406a5.jpg 1024X768 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=219457