Re: Joe's '49 Club Sedan

Posted by HH56 On 2020/8/1 14:20:27

Good job. All kind of commercial spacers are available that will fit the bolt holes but Packard did use that odd pulley hub with a dimension needing a large and non standard bore hole in the spacer.

I had to do something similar for my 356 engine with the compressor driven off the fan pulley so the fan would clear the side of the compressor belt. If I remember, that bore diameter is just a tad larger than those needed on the other engines. Fortunately my mini lathe was just barely able to handle the size.