Re: Replacing wires in the 47 Turn Signal Controller
Posted by Wesley Boyer On 2017/10/1 13:25:27
Okay, I got the wires replaced and inserted some pins. Next I braded the ends, don't look to good but I think it will hold. I used the smallest pop rivets to hold the unit together and mashed the ends down a little more. Checked it on the bench and electrical checkout checks good, mechanical checkout checks good. ready to be put back in. I'm calling this done. Wes
Attach file:
(135.28 KB)
(128.75 KB)
(165.77 KB)
(123.26 KB)
(114.84 KB)
(139.16 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=196231