Re: A Tale of Two Patricians
Posted by HH56 On 2018/6/27 22:01:29
You need to measure the diameter of the nut and the diameter of the hole. I would guess nut is around 1 1/4 and maybe 1/8 for the pin. You could pick up some 1/8 thick flat stock as narrow as possible and use a vise and hammer to sort of bend in the shape of the commercial tool. Drill a hole in the curved end and thread for a 6 or 8-32 screw for the pin. A bit crude but should work.
Attach file:
(16.70 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=203901