Re: A Tale of Two Patricians
Posted by HH56 On 2018/7/2 10:15:57
One more photo of the roll pin removal tool I made from a C clamp. The compete setup is shown in post #39 on page 4 of this blog. Forgot to mention that the pins are in very tightly so had to remove the wire lever that came on the C clamp and weld a nut to the end so I could use a gear wrench for added torque.
On the rectangular opening, I wonder if it is for a different heater. Some like the one in the 47 have a motor that extends under the floor. Maybe the square is to accommodate something like that or maybe a heater with different plumbing layout.
Attach file:
(48.56 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=204035